Shorelandr TA0031 Manuel d'utilisateur télécharger pdf

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0003329

ACCESSORY

TA0031-00

Roller Arm Assembly for SLR150T (Right)

TA0031-00

REAR ROLLER ARM ASSEMBLY FOR THE SLR150TAL

(RIGHT)

The rear roller system on the SLR150TAL consists of a right and

left-hand roller arm assembly. To make a complete rear roller sys-

tem requires both a TA0031-00 right-hand and a TA0030-00 left-

hand roller arm assembly.

Installation Instructions

Remove the wire harness and the taillight from the existing arm be-

ing replaced with the TA0031-00 located on the rear cross member

on the right hand side of the trailer. (See Picture to Identify). Re-

move the existing bunk or roller arm. Place the roller arm supplied

with the TA0031-00 into the mounting brackets on the rear cross

member and align the center hole with the hole in the mounting

brackets. Insert and 5/8” x 4 ½” hex bolt and secure with a 5/8”

lock nut.

Place a roller assembly on one end of the roller arm just installed.

Align the holes and secure with a ½” x 4” hex bolt and ½” lock nut.

Repeat this process on the other end of the roller arm.

Re-route the wire harness removed from the existing arm. Mount

the taillight removed and connect the wire harness to the taillight.

Re-install the rubber grommets to protect the wires.

Tighten all bolts. Assembly is complete.

Midwest Industries, Inc. Ida Grove, IA 51445 800.859.3028 www.shorelandr.com 0003329ACCESSORYTA0031-00Roller Arm Assembly for SLR150T (Right)TA

Modèles reliés TA0033

Pas de commentaire